Golf 2 1.3 pomoc - dijagnostika

Dakle potrebna mi je pomoc oko GOLF 2, 1.3, 87.god. kako i cime se pokrece dijagnostika, gde se nalazi dijagnosticki dzek i kako se citaju kodovi gresaka, samo da napomenem da ovaj model vozila nema CHECK ENGINE lampicu, bio bih zahvalan na svakoj pomoci?
Pozdrav!!!

Potpis

Maki

koliko ja znam na njemu je najveća elektronika automat žmigavca :)

Tesko da ce bit tu neke dijagnostike. Bilo je negdje u to vrijeme sistema upravljanja kod VW-a - "Digifant" ali sumnjam da se to
odnosi na ovaj motor. Ako nema lambda senzora - nista...

Potpis

Teaching to do it

Mislim da gresite, jeste kod njega se koristi sistem upravljanja "Digifant II" i on se koristio na vozilima proizvedenih od 1987-1992 na Golfu i Jetti e sad kako se pokrece dijagnostika to je problem, ako neko zna neka javi?

Potpis

Maki

Digifant II
To access the fault system, locate the white/red wire behind the fuse box (it might be hidden under the carpet), it is a single spade connector (red) coming out of the main engine harness from the firewall. (see note for 1987-1989 California cars below). Connect an LED test light between this point and a battery positive (+). The LED should light briefly when the ignition is switched on, indicating the system is responding. The LED should go out. If not, a fault is stored. To check faults, connect a jumper wire between the same test pin connector and ground (-) for at least five seconds. Remove the jumper, and the LED should flash one long pulse, then several shorter pulses (with spaces) indicating codes. Please click here for an example.

The example picture above would indicate a 1234 code. Connect the jumper again for at least 4 seconds to advance to the next code. When "0000" (2.5s flashes at 2.5s intervals) or "4444" is read, the sequence is completed. To clear the codes, connect the jumper with the ignition off, then turn it on. After 5 seconds, remove the jumper, and "4444" should be read. NOTE: Code 1111 is a common misdiagnosis. It will almost always come up shared with any other code. If you see this code by itself, check all the wiring, and as a last resort, replace the control unit.

NOTE: On 1987-1989 California emissions models, there is a "CHECK" button on the dashboard. It acts as the jumper wire and the LED; follow the directions above, but depress the button as if you were connecting the jumper wire, and the CHECK light will flash codes.
A2Resource > Electrical Systems > Codes > Digifant II
Code Description Action
2142 Knock sensor Defective knock sensor or wiring. Control unit not recognizing knock signal
2232 Air flow sensor potentiometer Defective air flow sensor potentiometer or wiring
2312 Coolant temperature sensor Defective coolant temperature sensor or wiring
2322 Intake air temperature sensor Defective intake air temperature sensor or wiring
2342 Oxygen sensor Defective oxygen sensor or wiring
4444 No faults recorded -
0000 End of fault code sequence -

Internet je cudo.
Imas PP

Potpis

Teaching to do it

tko?

Mislio sam na makkkija79 , sorry :) al' eto sad imas i ti
pozz

Potpis

Teaching to do it