edituj xorg.conf tamo gde se pominju vertikalna i horizontalna rezolucija, pa postavi maksimalne vrednosti koje tvoj monitor moze da izdrzi (vidi knjizicu od monitora)...
ono sto ti monitor prijavi u meniju je da radi na 75Hz i onaj ko je navikao na veci refresh rate vidi kako monitor treperi a cinjenica je i da je na manjoj frekvenciji slika mutnija.
evo primer za moju sekciju:
Code:
# **********************************************************************
# Monitor section
# **********************************************************************
# Any number of monitor sections may be present
Section "Monitor"
Identifier "Samsung"
# HorizSync is in kHz unless units are specified.
# HorizSync may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY. REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.
HorizSync 30-96
# HorizSync 30-64 # multisync
# HorizSync 31.5, 35.2 # multiple fixed sync frequencies
# HorizSync 15-25, 30-50 # multiple ranges of sync frequencies
# VertRefresh is in Hz unless units are specified.
# VertRefresh may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY. REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.
VertRefresh 50-160
EndSection
samo sto je moj monitor SyncMaster 957p.... znaci NEMOJ kopirati.....
Potpis
Registered Linux user #338733
, mrzi ljude da citaju tamo neka uputstva.. Sta ima lose u tome?