HP Designjet 130NR, pruge prilikom stampe

Imamo HP Designjet 130NR Plotercic u firmi sa ugradjenim CISS sistemom boja koji je radio neko vreme kako treba, kupljen je inace polovan.
Od skoro je poceo da pravi problem, prilikom stampe krene da radi kako treba nekih 15-20cm pa onda pocnu da ostaju prugice na papiru. Izmenjali smo sve glave i ubacili smo druge boje i opet isti problem se ponavlja. Da li je neko imao iskustva ili zna nekog pametnog servisera koji bi to mogao da resi posto je bilo par njih i nisu znali sta je u pitanju

Potpis

Do not try to bend the spoon, that's impossible.
Instead just try to realize the truth.
What truth?
There is no spoon.
There is no spoon?
Then you'll see that is not the spoon that bends, it is only yourself.

Da li se problem javlja na svim vrstama papira i dali koristite papir namenjen tom ploteru?

Bas na svim vrstama papira i na canvasu.
Kontaktiracemo od ponedeljka neki hp ovlasceni servis pa cemo videti sta dalje

Potpis

Do not try to bend the spoon, that's impossible.
Instead just try to realize the truth.
What truth?
There is no spoon.
There is no spoon?
Then you'll see that is not the spoon that bends, it is only yourself.

Nemam iskustva sa tim ploterom, ali na Encad-u takav problem se resava kalibracijom glava ili eventualnom zamenom kliznih prstenova.

Da li radite redovno kalibraciju?

ma sve smo kalibrisali sto puta, testove sve odradi perfektno ali kad treba da odstampa tu zakaze, ubacio sam i novi firmware i opet isto se sve desava

Potpis

Do not try to bend the spoon, that's impossible.
Instead just try to realize the truth.
What truth?
There is no spoon.
There is no spoon?
Then you'll see that is not the spoon that bends, it is only yourself.