Power-line Internet
Main article:
Power line communication
This is a new service still in its infancy that may eventually permit broadband Internet data to travel down standard high-voltage power lines. However, the system has a number of complex issues, the primary one being that power lines are inherently a very noisy environment. Every time a device turns on or off, it introduces a pop or click into the line. Energy-saving devices often introduce noisy harmonics into the line. The system must be designed to deal with these natural signaling disruptions and work around them.
Broadband over power lines (BPL), also known as Power line communication, has developed faster in Europe than in the US due to a historical difference in power system design philosophies. Nearly all large power grids transmit power at high voltages in order to reduce transmission losses, then near the customer use step-down transformers to reduce the voltage. Since BPL signals cannot readily pass through transformers, repeaters must be attached to the transformers. In the US, it is common for a small transformer hung from a utility pole to service a single house. In Europe, it is more common for a somewhat larger transformer to service 10 or 100 houses. For delivering power to customers, this difference in design makes little difference, but it means delivering BPL over the power grid of a typical US city will require an order of magnitude more repeaters than would be required in a comparable European city.
The second major issue is signal strength and operating frequency. The system is expected to use frequencies in the 10 to 30 MHz range, which has been used for decades by licensed amateur radio operators, as well as international shortwave broadcasters and a variety of communications systems (military, aeronautical, etc.). Power lines are unshielded and will act as transmitters for the signals they carry, and have the potential to completely wipe out the usefulness of the 10 to 30 MHz range for shortwave communications purposes.