Pomoć za JET kada ima puno forma i modula u aplikaciji pa se ne može prevesti u MDE

Potrebna pomoć oko pretvaranja baze u MDE fajl.Kada hoæu da pretvorim bazu u MDE fajl dobijem ovu grešku jer nemogu da prevedem iz MDB u MDE "This error is usually associated with compiling a large database into an MDE file. Due to the method used to compile the database, a considerable number of TableID references are created for each table. The Microsoft Jet database engine version 4.0 can only create a maximum of 2048 open TableIDs at one time. Exporting a database as an MDE potentially can exceed this limit if the database has a large number of objects (table, macro, form, report, etc).
There is no accurate method to estimate the number of TableIDs the Jet database engine uses during the process of compiling a database as an MDE. However, each VBA module and each form uses one TableID, as a result, if the database has 500 forms, and each form's HasModule property is set to Yes, as many as 1,000 TableIDs are used."

Izgleda da seadi o tome što imam puno formi i modula u bazi pa je potrebno da pomoæu JETCOMP aplikacijem to izvedem ali ja to ne znam kako se koristi...
Možda sam u krivu pa molim za pomoæ kako da ipak prevedem bazu u MDE...

Unaprijed Hvala !!!

Ima li tko odgovor...

Davno sam ja imao taj problem, ne znam u cemu je problem ali sam ga resio.
-Access 2000 ( sada radim sa 2003 )
-Izjavljuje da imam mnogo formi i modula, nije hteo ni compact and repair
-Imao svega desetak formi
-Otvorio novi fajl (novu bazu) i kopirao deo po deo iz baze koja je pravila probleme.
-Utvrdim da mi jedna forma pravi probleme i to neka jednostavna (za unos artikala ) bez makroa,....
-Ponovo napravio istu takvu formu i radilo je bez problema.

Nisam shvatio zasto se to desilo i nije mi se vise nikad to desilo ali sam uspeo resiti problem.
Nadam se da sam ti pomogao, posalji odgovor..