Citat:
mmirilovic:
Takođe u konzoli možeš da oktucaš "cat /proc/driver/hsf/0/lastcallstatus", i
dobićeš razlog zašto je došlo do prekida veze.
OK. Otkucao sam i dobijam sledecje:
Code:
<#UG VERSION=3>
<DRIVER VERSION=hsfmodem-7.18.00.05full>
<CALL SETUP RESULT=Detected Data Answer Tone>
<MULTIMEDIA MODE=Data Only>
<DTE-DCE MODE=Async data>
<V.8 CM="">
<V.8 JM="">
<RX SIG PWR DB=0, TX SIG PWR DB=0, S/N RATIO DB=0>
<RTD=-3>
<TX MOD=V.90, TX SYMBOL RATE=3200, TX CARRIER FREQ=1920>
<RX MOD=V.90, RX SYMBOL RATE=8000, RX CARRIER FREQ=0>
<TX FIRST RATE=14400, RX FIRST RATE=44000>
<CARRIER LOSS=0, RATE RENEG=18>
<RETRAINS REQ=0, RETRAINS DET=2>
<TX FINAL RATE=14400, RX FINAL RATE=34667>
<PROTOCOL=LAPM>
<EC FRAME SIZE=100>
<EC LINK TIMEOUTS=0>
<EC LINK NAKS=0>
<COMPRESSION=V44>
<COMPRESSION DICTIONARY SIZE=800>
<TX FLOW CONTROL=0>
<RX FLOW CONTROL=0>
<TX CHARS SENT FROM DTE=18E26F>
<RX CHARS SENT TO DTE=4A0F49>
<TX CHARS LOST=0>
<RX CHARS LOST=0>
<TX FRAME COUNT=2928>
<RX FRAME COUNT=5020>
<TX FRAME ERROR COUNT=6>
<RX FRAME ERROR COUNT=41>
<TERMINATION CAUSE=n400 exceeded>
<CALL WAITING EVENT COUNT=0>
<LSD Vdd=0, Power Bits=0>
<V8BIS DSP VER=0>
<RATE RENEG REQ=0, RATE RENEG DET=18>
<RBS=0, AltRBS=0>
<DIG PAD DET=0, DIG LOSS EST=0, IMD RATIO=0, SPEED DROP=0>
<HS CNT=0, Det1=E0, Res1=148, LAPM=5>
<EQM=0, TRAINING EQM=0>
<HandShake Time=17.364>
<DIB ERROR COUNTERS=0, 0, 0, 0, 0, 0, 0, 0>
<DIB ERROR COUNTERS=0, 0, 0, 0, 0, 0, 0, 0> hmm.. ???
"The world holds two classes of men - intelligent men without religion, and religious men without intelligence."
patchovani linuxant driver-i i ICMP rupa
)
