Citat:
nus: a sam driver se sastoji iz dva dela, jedan je driver a drugi kernel-module
Driver se sastoji samo iz drivera, to drugo na shta mislish je podrshka za interni ili externi agp modul u kernelu (nema veze sa drajverom, to je ono shto drajver koristi za podrshku). Na
www.ati.com imash drajvere, skini ih odatle, ali pre nego shto krenesh u akciju kompajliranja, predlazhem ti da postupish po sledecem:
Citat:
The display driver requires POSIX Shared Memory to be enabled on the system in order to run these applications correctly. This feature should be enabled by default on most current Linux distributions, but may be disabled intentionally by some system administrators or not included in older distributions.
To enable POSIX Shared Memory on your system, perform the following as root:
1. Add the following line to /etc/fstab (if it isn't there already): tmpfs /dev/shm tmpfs defaults 0 0
2. Mount shared memory as follows: mount /dev/shm
3. Issue the following command to check that it mounted properly: mount | grep "shm"
If the mount was successful, then the following output (or similar) should appear:
tmpfs on /dev/shm type tmpfs (rw)
At this point, POSIX Shared Memory is enabled. Your 3D applications should run properly and the error message above should no longer occur.
If the output from this command is blank, then the mount failed.
If /dev/shm fails to mount, then this feature may not be turned on in your Linux kernel. In this case we recommend upgrading to a more recent Linux kernel, or contacting your Linux Distribution vendor for more information on enabling POSIX Shared Memory.
Ukoliko u kernelu imash chekiranu opciju za korishcenje interne podrshke za agp, predlazhem ti da nju koristish, jer ovi drajveri loshe stoje sa eksternom podrshkom. Ukoliko nemash, predlazhem rekompajliranje kernela.
Nakon svega ovoga, baci se na kompajliranje drajvera, i imacesh full 3d podrshku (OpenGL) koji evo i kod mene shljaka kao bombona. Chak pichim Quake 3 kad mi dosadno