primary EIDE controller is operating outside of normal specificationPrva je:
-------------------------------------------------------------------------------------
Warning: Dell`s Disk Monitoring System has detected that drive 0 on the primary EIDE controller is operating outside of normal specification. It is advisable to immediately back up your data and replace your harddisk drive by calling your support or Dell Computer Corporation.
Strike the F1 key to continue, F2 to run the setup utility.
---------------------------------------------------------------------------------
Druga je kad se pritisne F1, onda on pokusa da startuje i pojavi se plava poruka:
---------------------------------------------------------------------------------
A problem has been detected and windows has benn shut down to prevent damage to your computer.
UNMOUNTABLE_BOOT_VOLUME
If this is the first time you`ve seen this stop error screen, restart your computer. If this screen appears again. folow these steps:
Check to make sure any new hardware or software is properly installed. If this is a new installation, ask your hardware or software manufacturer for any windows updates you might need. If problem continue, disable or remove any newly installed hardware or software. Disable BIOS memory option such as caching or shadowing. If you need to use Safe Mode to remove or disable components, restart youy computer, press F8 to select Advanced Startup Options, and then select Safe Mode.
Technical information:
*** STOP: 0x000000ED (0x81708E30, 0xC0000032, 0x000000000, 0x00000000)
----------------------------------------------------------------------------
Sunca li ti žarevog!!
